HGP AEROSOL PAINTS_SPECIAL COLOUR DIY_MALAYSIA

DESCRIPTION:

• HGP Aerosol paints_Special Colour is precision cut resin coated chips for adding intense sparkle to custom paint jobs. 
• Brilliant, jewel-like colours.

Main component is Acrylic modified Resin and 2K computerized paint system for Decoration.

SUBSTRATE: 

• Surface with standard coatings in good condition. The primers are coated and flattened well. Should use HGP’s primer paints.

SPRAYING TECHNIQUE:

• Shake the aerosol can for at least 2 minutes before use;
• Press the button on the spray head. Try on a hard cover before painting;
• Spray distance: 10 – 15cm;
• Spray 1 single coat (not too wet). Then spray 1 couple coats; 
• Drying times between coats: 3 to 5 minutes (touching does not stick);                                      
• After 10 – 20 minutes, all of finish coating is dried completely, applicartion for 1K or 2K Clear.

RECOMMENDED USE:

1. Surface preparation
2. Clean surface with water and soap. Rinse and dry.
3. For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free. Wipe dry with a clean cloth.
4. Repair according to damage. Adding mattic on the scratched and roughed parts,..
5. HGP Aerosol paints–1K or 2K primer paints.
6. Sand primed surfaces wet or dry with P600-P800 sandpaper, degrease and dry before applying HGP Aerosol paints_Special Colour.

REPAIR SYSTEM

Common Repair

• Pay attention to the method of application.The spray must be in according to the procedure and apply coating within 20 minutes. Avoid over spraying.

Between the old and new paint layers: Apply the method of 2K Fade out Thiner.

① Coating the first of HGP Clear on over surface, spray  more over on the areas of repainting spots;
② Coating the second of HGP Clear, spray  more over on the area of repainting spots;
③ NO RECOMMENDED: Applied HGP Aerosol -2K Fade out Thiner on the sanded areas by P100 to lower the lid between the old and new paint layers that will be not finded them in polishing. ONLY USE INCASE REPAINTING.

FIRST AID MEASURES:

• Inhalation: Remove the victim to fresh air area. If rapid recovery does not  occur, perform artificial respiration and obtain medical attention.
• Skin Contact: Remove contaminated clothing. Wash skin immediately with plenty of water and soap. If persistent irritation occurs, obtain medical attention.
• Eye Contact: Immediately flush the eye with running water for at least 15 minutes. If persistent irritation occurs, obtain medical attention.
• Ingestion: If the patient conscious, give plenty of water to drink. Do not  induce vomiting. If rapid recovery does not occur, obtain medical attention.

SHELF LIFE:

• 2 years subject to proper storage conditions.
• Recommended Storage Temperature: not under -5°C and over 25°C.
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use to clear the nozzle. If the nozzle becomes blocked, remove it from the can and soak it in gentle thinners.

PACKING: 400ML Aerosol can