HGP AEROSOL PAINTS_ETCH PRIMER 13483 DIY-MALAYSIA

DESCRIPTION:

• HGP Aerosol paints_ Etch Primer 13483 has a component of Acid Phosphoric that engraves on metals and anti-rust is extremely good.
• HGP Aerosol paints_ Etch Primer 13483 promotes strong surface adhesion.
• Suitable for all metal surafces including: Ferrous & non-ferrous; Alloys & Brass; Steel, Zinc coated steel, Aluminium.

PROPERTIES:

• 1K Etch Primer 13483.
• Substrate:        Matiing coating
• Flash point:     Under 23°C
• Color:              Light Green

RECOMMENDED USE:

Surface preparation

• For best results, ensure the surface is thoroughly cleaned, degreased, dried and dust free. Wipe dry with a clean cloth.

Spraying Technique

• Shake the aerosol can for at least 2 minutes before use;
• Press the button on the spray head. Try on a hard cover before painting;
• Spray distance: 10 – 15cm;
• Spray 1 single coat (not too wet), flash off 5 to 10 minutes (touching does not stick). Then spray 1 couple coats;
• Drying times: 15 - 30 minutes.

FIRST AID MEASURES:

• Inhalation: Remove the victim to fresh air area. If rapid recovery does not  occur, perform artificial respiration and obtain medical attention.
• Skin Contact: Remove contaminated clothing. Wash skin immediately with plenty of water and soap. If persistent irritation occurs, obtain medical attention.
• Eye Contact: Immediately flush the eye with running water for at least 15 minutes. If persistent irritation occurs, obtain medical attention.
• Ingestion: If the patient conscious, give plenty of water to drink. Do not  induce vomiting. If rapid recovery does not occur, obtain medical attention.

SHELF LIFE:

• 2 years subject to proper storage conditions.
• Recommended Storage Temperature: not under -5°C and over 25°C.
• Aerosol cans should be stored for two hours at room temperature before use. For long term storage, keep in a dry well ventilated area and away from direct sunlight and frost. To maximize the lifespan of your aerosol, always invert the can and spray upside down for a few seconds after each use to clear the nozzle. If the nozzle becomes blocked, remove it from the can and soak it in gentle thinners.

PACKING: 400ML Aerosol can